How do you call on a Cisco phone 7962?
Press the Speaker button, and then dial. Press the New Call soft key, and then dial. If you are using a headset, press the Headset button, and then dial.
How do I reset my Cisco 7962 phone?
Performing the Factory Reset on Cisco 7942, 7962 IP Phones
- Unplug the power cable from the phone and then plug it back in. The phone begins its power up cycle.
- While the phone is powering up, and before the Speaker button flashes on and off, press and hold #.
- Release # and press 123456789*0#.
How do you use the intercom on a Cisco IP Phone 7962?
Place an intercom call Press intercom button, enter a number if necessary, and speak after you hear the tone. Start a standard (ad hoc) conference call Press more > Confrn, dial the participant, then press Confrn again.
How do I make outgoing calls on my Cisco phone?
You can use your phone to place a call outside your organization.
- Dial your dial out digit (8 or 9) to open an external line and gain outside access.
- Local calls: Dial your dial out digit (8 or 9), then 1, followed by the full 10 digit telephone number.
How do I use my Cisco office phone?
- Procedure.
- Step 1 Verify that you are on an active call (not on hold).
- Step 2 Press and release the hookswitch to get a dial tone.
- Step 3 Enter the transfer recipient’s phone number.
- Step 4 Wait for the recipient to answer. You may skip to Step 5 while the call is ringing.
- Step 5 Hang up. The transfer is complete.
How do I reset my Cisco phone PIN?
- Procedure.
- Step 1 In the Messaging Assistant, from the Passwords menu, select Change PIN.
- Step 2 On the PIN page, enter your new password, then enter it again to confirm it. Use digits 0 through 9.
- Step 3 Select Save.
How do I connect my Cisco phone to my network?
Connecting your CISCO VoIP Phone Device to the Network
- Locate the white ethernet jack in your workspace.
- Plug one end of an ethernet cable into the white jack, and the other end into the ethernet port on the back of the phone device.
- The phone will power on if connected properly.
How do you make an intercom call?
To make an intercom call:
- Pick up the receiver and listen for dial tone.
- Dial your own phone number or *53 depending on your location and whether or not you have infiNET service.
- Hang up and your phone will ring.
- Wait for someone to answer the phone.
How do I unlock my Cisco IP phone?
How do I unlock a Cisco IP phone? 1. Unlock Settings – *, *, #. Go to the Settings page of the phone. While in the settings page, press *, *, # (star, star, pound) about 1/2 second apart. The phone will display “Settings Unlocked” and allow you to make changes.
How to use your Cisco IP phone?
Cisco IP Phone, allowing you to place, receive, and otherwise handle calls. If you install Cisco IP Communicator on a laptop or portable computer, you can use Cisco IP Communicator (and all of your phone services and settings) from any location where you can connect to the corporate network.
How to find the IP address on a Cisco phone?
Objective. The objective of this article is to provide the necessary steps for finding the IP address of a Cisco 6800 Series Phone.
How to upgrade firmware to 7962?
Using your web browser,login to the Cisco IPT Platform Administration web page