Why is my status light blinking on my Harman pellet stove?
A six blink status may be set if the stove is allowed to run out of pellets. To reset, turn mode selector to “OFF” then back on to the desired mode. If the unit was not out of pellets, see Troubleshooting section of owners manual for more details.
How do I reset my Harman pellet stove?
Once the stove runs out of pellets, it will no longer be able to heat. In this way, you have effectively reset it. Alternatively, you can reset your pellet stove by turning it off, waiting a few seconds, and then turning it back on again.
Why does my Harman pellet stove keep shutting off?
The most likely culprits for this issue are – a dirty unit blocking proper airflow, a neglected/dirty heat exchanger, and incorrect blower settings. If none of these are the cause, and you purchased your fuel from Woodpellets.com, give our Quality Control Manager a call to walk you through what’s happening.
What does e2 on pellet stove mean?
If the unit does not reach its minimum operating temperature within the 20 minute startup period, it will shut down and display the “E-2” code.
Why is my pellet stove not igniting?
Clean all vents, check and repair/replace all gaskets, adjust damper or airflow setting. Adjust air-to-pellet ratio by increasing air flow. Adjust air-to-pellet ratio by increasing air flow and/or decreasing feed rate. Adjust air-to-pellet ratio by increasing air flow and/or increasing feed rate.
How do you troubleshoot a pellet stove?
Troubleshooting Your Pellet Burning Issues
- Thoroughly clean and inspect hopper, auger plate, and switches.
- Inspect and clean auger, auger motor, combustion blower, and convection blower, and repair as necessary.
- Inspect all seals throughout the unit.
- Thoroughly clean out exhaust pipes and venting to the outside air.
Why is my Harman pellet stove not igniting?
Low Air Draft If ash, soot, unburned pellets or any other debris obstructs the flue or the air holes, the stove won’t ignite because the combustion chamber lacks the air it needs.
What does the low limit switch do on a pellet stove?
The “LOW LIMIT SWITCH” is the white ceramic disk by the exhaust fan. It is timed by the computer that if after 30 minutes, the stove exhaust fan will simply turn off and the stove will shut down if that switch does not feel the exhaust is above 120 degrees.
Do pellet stoves shut off automatically?
Pellet stoves are electrical and highly automated heating appliances allowing them to be turned on and off at the touch of a button with minimal manual input required. A pellet stove won’t start and stop in an instant but will take a short while to start a fire and cool down after one.
What does E3 code mean on my pellet stove?
E3 error means the hopper ran out of pellets. This could also be a bad sensor. So I would check or replace the Low Limit Snap disc before replacing the circuit board.
Can I manually light my pellet stove?
Pellet stoves with automatic ignition require less work to light. If it requires you to do it manually, you’ll need wood pellets, a gel accelerant, fire-resistant gloves, and a long-reach butane lighter.