Where does the damper go on a swamp cooler?
The damper is usually a sheet of metal, similar to a cookie sheet, that is installed in a slot somewhere in the duct at or near the cooler. The purpose of the damper is to close off the duct in the winter so your home doesn’t lose heat. Make sure the slot is sealed.
How can I make my swamp cooler quieter?
Tips for Reducing Evaporative Cooler Noise
- Stand it on a mat. One of the biggest sources of noise with evaporative coolers is transmission into a surface.
- Place a barrier in front of the unit.
- Build a quiet box.
- Run the cooler on a lower setting.
- Keep the cooler away from walls.
- Buy a higher end unit.
Why do swamp coolers need a window open?
A Swamp Cooler Will Require Open Windows In order for the unit to work properly, the pads should be damp, not soaked. There is a pan at the bottom of the air conditioner. There is also a small pump in the pool of water which lifts the water onto the pads.
Should I cover my swamp cooler in the winter?
After cleaning your system thoroughly, you should cover your cooler with some kind of protective cover. Protective covers keep winter dust from getting into the motor and air ducts so when you turn your system on in the spring you don’t get all that dust into your home.
How do I get my swamp cooler ready for summer?
8 Steps to Get a Swamp Cooler Ready for Summer
- 8 Steps to Get a Swamp Cooler Ready for Summer.
- Step 1: De-Winterize.
- Step 2: Remove the Casing of the Cooler.
- Step 3: Clean the Inside of the Unit.
- Step 4: Replace the Filter.
- Step 5: Connect the Water Hose.
- Step 6: Inspect for Leaks.
- Step 7: Run a Complete Systems Check.
Why is my swamp cooler so loud?
When the belt is bad, it can be replaced. When the float valve gets loose or loses its seal, it can move around and make loud clicking and clattering noises. This problem is easy to fix by replacing the valve if needed or just repositioning it. Tubes that get loose might also cause a similar sound.
What happens if you run swamp cooler with windows closed?
It is essential to keep the windows closed so the cooled air does not escape. However, swamp coolers work differently. They pull fresh air into a room, and as it passes over damp pads, it cools the room. As the cool air fills the room, the hotter air is forced out.
How many windows should be open for a swamp cooler?
You should have 1 to 2 square feet of a window or open door space for every 1,000 cubic feet per minute (CFM). For example, you have a 4,000 CFM system and windows with 4 square feet of space to the outside when opened. You need 4-8 square feet of space, which is 1-2 windows open, to run this system.