What kind of oil do you put in a Wacker plate?
Use the correct quantities and lubrication type, 10W-30 motor oil.
How do you troubleshoot a plate compactor?
Warning
- Check the spark plug and set it to the proper gap if the machine is difficult to start.
- Check the spark plug wiring.
- Check the ignition coil and replace it if it is defective.
- Check the wiring for the “On/Off” switch and replace it if it is defective.
- Check the air cleaner filter and fuel filter.
Should I wet gravel before compacting?
You don’t necessarily need to wet gravel before compacting, however a light amount of water can help to keep dust levels down. Just be sure not to make the area too wet.
Can you use a Wacker plate on wet soil?
If you put a whacker on it when wet all you will do is drive the water to the top surface and if you rotavate it, all you will do is bring the clay to the surface as well. Typically you would put in some land drains and take them to a piped drain or into a soak away.
Does a Wacker plate need oil?
All that is required is 5 ounces of ATF (automatic transmission fluid). Service Note: New style Wacker WP1540 and WP1550 plate compactors require 5.07OZ or . 15L of 75w-90 gear oil.
How do you service a compactor?
Recommended Weekly Maintenance
- Check fluid level in hydraulic oil tank. Add oil as necessary.
- Check hydraulic hoses and fittings for leaks.
- Remove dust and dirt from outside of the control box.
- Wipe off any grease, oil or moisture on power unit.
- Observe one complete cycle to verify proper operation.
How many times can you compact gravel?
It is a good idea to go over the surface three to four times with a plate compactor before introducing the sub-base material. Once the surface of the excavated area is sufficiently compacted, sub-base material may be added.
How do you use the throttle on a WP 1550a/aw?
Safety Information WP 1550A/AW wpm_si000327gb.fm16 Push or turn engine switch to OFF position. Open the choke. Place throttle in the FAST position. Throttle control lever: Turtle = Idle or Slow Rabbit = Full or Fast
How do I perform the maintenance on my WP 1550a/aw?
Maintenance WP 1550A/AW wpm_tx001132gb.fm30 5.7 Engine Oil See Graphic: wc_gr000022 5.7.1 Drain the oil while the engine is still warm. 5.7.2 Remove the oil filler plug (a) and the drain plug (b) to drain the oil.
What are the safety labels for the Wacker Neuson 1550a/aw?
Safety Information WP 1550A/AW wpm_si000327gb.fm12 2.6 Warning and Informational Labels Wacker Neuson machines use international pictorial labels where needed. These labels are described below. Label Meaning WARNING! To prevent hearing loss, wear hearing protec- tion when operating the machine.
What kind of air cleaner does a WP 1550a have?
WP 1550A/AW Maintenance wpm_tx001132gb.fm31 5.8 Air Cleaner See Graphic: wc_gr000025 The engine is equipped with a dual element air cleaner. Service air cleaner frequently to prevent carburetor malfunction. NOTICE: NEVERrun engine without air cleaner. Severe engine damage will occur.