What is the default password for Cisco ASA 5505?

What is the default password for Cisco ASA 5505?

The default username for your CISCO ASA 5505 is Cisco. The default password is Cisco.

What is password of Cisco ASA?

Question: What is the default username and password for Cisco ASA firewall? Enable password is blank by default.

What is the default password for Cisco ASA 5506?

Cisco
Enter the username Cisco and the password Cisco.

How do I setup my Cisco ASA 5505?

Cisco ASA 5505 configuration

1. Step1: Configure the internal interface vlan.
2. Step 2: Configure the external interface vlan (connected to Internet)
3. Step 3: Assign Ethernet 0/0 to Vlan 2.
4. Step 4: Enable the rest interfaces with no shut.
5. Step 5: Configure PAT on the outside interface.
6. Step 6: Configure default route.

How do I reset my Cisco ASA 5505 without a password?

1. After you open connection, press enter a couple of times, and you should get a prompt like: ‘ciscoasa>’
2. type ‘enable’ to go to enable mode.
3. type ‘config t’
4. type ‘config factory-default’
5. hit spacebar when the ‘more’ is displayed.
6. type ‘reload save-config noconfirm’

How do I reset my Cisco ASA password?

Reset Password in Cisco ASA Firewall

1. Step 1: Login to Cisco ASA device with console cable and reboot the device.
2. Step 2: Press ‘ESC’ key or ‘BREAK’ key on the keyboard to break the boot process.
3. Step 3: Now, here is the trick.
4. Step 4: Reboot the device.
5. Step 5: When the ASA is booted, it will not ask for password.

How do I reset my Cisco ASA 5505 password?

How do I reset my Cisco ASA 5505 to factory settings?

How do I recover my firewall password?

To recover passwords, perform the following steps:

1. Console into the ASA.
2. Reboot the ASA.
3. Press the escape key during reboot to enter ROMMON.
4. Tell the firewall to ignore the startup config on next reload: rommon #1> confreg.

How do I reset my ASA 5505 without a password?

How do I change my Cisco ASA 5505 username and password?

To set the enable password on your Cisco ASA 5505:

1. Get into the command line. I prefer using the console cable to directly connect.
2. Hit enter a few times to get the prompt.
3. Type ‘ena’ to enter enable mode.
4. Type ‘config t’ .
5. Type ‘enable password PaSsWoRd’ , replacing the second, ‘PaSsWoRd’ with desired password.