What does sh mean on a Prodigy P2 brake controller?
Expert Reply: The SH code on the Prodigy Brake Controller, # 90885, indicates that while idle, the brake controller is sensing a short in the brake wire. Tekonsha states that some test lights or non-Tekonsha testers can cause this problem.
What does PL stand for on a Prodigy brake controller?
On a Prodigy P2 trailer brake controller # 90885 the error code PL indicates power loss, that the controller is losing its 12V power connection to the battery while your foot is on the brake pedal.
What is NC on Prodigy brake controller?
The nc code on the Tekonsha Prodigy brake controller indicates that no trailer is connected. When you step on the brake pedal though it should still say that the trailer is not connected. It is possible that there is a short being caused by a dirty or corroded connector.
Who makes Prodigy brake?
Tekonsha
The self-leveling feature also makes the Prodigy easy to install: Simply mount it in your cab at any vertical angle (it has 360-degree rotation)….Prodigy® P2 Trailer Brake Controller, Proportional, 1 to 4 Axles.
| Brand: | Tekonsha |
|---|---|
| Warranty: | Limited Lifetime Warranty |
| UPC: | 783192026033 |
| Dimensions: | 3.1″ x 4.4″ x 10.5″ (Shipping) |
| Finish: | Gray Plastic |
How do you reset a prodigy P2 brake controller?
The first step that we will want to take is to reset the brake controller. This is done by simply unplugging the brake controller for approximately 20 seconds and then reconnecting the brake controller.
What does flashing sh mean on brake controller?
Troubleshooting Prodigy Brake Controller that Flashes SH Code The error code you are reading indicates that there is a short circuit somewhere in the brake outupt circut on your trailer. Most likely, there is a pinched wire or at some point the wire insulation has cracked or been worn to the point where the…
What does OL mean on a brake controller?
The OL or overload error code indicates a short in the brake output circuit. Start by examining the trailer connector. Make sure that the pins on the vehicle side of the connection and the sockets on the trailer side are not damaged or corroded.
How do you reset a prodigy brake controller?
What does 5h mean on a Prodigy brake controller?
The code 5. H (flashes 2x per second or a steady display) on the Prodigy P2 # 90885 indicates the brake wire is seeing a short during idling conditions.
How do you set P2 prodigy?
First step is to connect your trailer to your tow vehicle. Next, with the engine running, hold the manual lever full to the left and set the power knob to indicate approximately 6.0. Now you will want to drive your tow vehicle and trailer on a dry, level, paved surface and fully apply the manual lever.