Is there a tool to remove spark plug wires?
Amazon.com: ARES 70053 – Spark Plug Plier Boot Removal Tool – Remove Hard to Reach Boots and Wires Without Damaging Them : Automotive.
What size socket do I need for spark plug?
You’ll need just a few tools to change out the spark plugs on your car. The most important tool is a socket wrench with an extension and a spark plug socket. Spark plug sockets come in two sizes: 5/8 inches and 13/16 inches. Most spark plug sockets have a rubber insert that holds the plug snugly in place.
Can I use pliers to remove spark plug?
Lisle 51410 Offset Spark Plug Boot Removal Plier The tool measures 7 inches in length and features an offset tip that is able to remove spark plug boots that are in a hard-to-reach spot. The pliers open to 5/8 of an inch, which is just enough to get the job done without damaging any of the spark plug wires.
How do you separate spark plug wires?
Grab firmly onto the spark plug wire boot, then twist in either direction and pull off simultaneously. This ensures the wire will break free is slightly corroded. The rotation also allows for the connection to unclip from the top of the spark plug much easier, putting less strain on the wire.
Do you need to disconnect battery to change spark plug wires?
It’s also good practice to disconnect the negative terminal of your car battery when working on anything electrical. Be sure to let your car’s engine cool thoroughly before replacing your spark plugs. This will make removal of the plugs and the spark plug wire or ignition coil boot easier.
How do you change spark plug wires?
Installing the New Spark Plug Wire Set
- Match the longest wire in the new set with the longest wire on the vehicle, then match the next longest, and so forth.
- To install a new wire, push the new spark plug wire boot on one end to the module, and then push the next end onto the spark plug.
How do you remove spark plug wires from a distributor cap?
When removing wires from the spark plug or distributor cap, twist or rotate the boot to loosen it from the plug. Do not jerk or tug on the wires or you may break the connection. Be sure to only pull on the boot; do not pull on the cable itself.
What can I use as a spark plug socket?
no you don’t need a spark plug socket to remove and install spark plugs. A deep socket in the correct size will work in most cases, if enough patience is used and maybe some pliers to go along with the socket.
https://www.youtube.com/watch?v=LBHqkKfimps