Is the Sterling 10.25 limited slip?
Sterling 10.25″ Limited Slip Diff for 1985-1997 Ford F250, F350 Rear Axle.
Is the Sterling 10.5 Axle good?
At the end of the day, the Sterling 10.5 isn’t a bad rear axle, it simply has a weak spot that needs to be addressed. We’re even willing to go out on a limb and say it’s one of the best-value full-float axles available. Well, next to the GM 14-bolt, of course. Oh, yes.
Is the Sterling 10.5 limited slip?
The 1999-2010 10-1/2″ Ford Sterling Rear Axle was built with two types of Limited Slip Differentials. Limited Slip equipped vehicles with 5.4L gas V8 engines typically have a differential with a straight cross shaft and two pinion mate gears.
Is a sterling 10.25 a 1 ton axle?
Strapped under many 3/4- and 1-ton Ford pickups are rear axles that are somewhat mysterious. Often referred to as the Sterling 10.25- or 10.50-inch axles, they’ve been used in the vast majority of aforementioned trucks since the mid-’80s, yet most folks don’t know much about them.
How much does a sterling 10.5 weight?
It weighs in at approximately 333 pounds in single rear-wheel versions. The ring gear diameter and pinion shaft length are both 10 1/2 inches.
What does a sterling 10.25 weigh?
The 10 1/2-inch (commonly referred to as the “Sterling 10 1/2”) is a full-float axle with disc brakes found in 1999-2010 Ford Super Duty F-250 and Super Duty F-350 trucks. It weighs in at approximately 333 pounds in single rear-wheel versions.
What did the Sterling 10.25 come in?
There were two versions of the Sterling 10.25. The first version was produced from 1985 to 1992. The second version, produced from 1993 to 1997 featured a stronger pinion/yoke.
How much does a sterling axle weigh?
What does full floating axle mean?
For a full-floating system, the axle shaft only serves to transmit the rotational torque from the differential out to the wheel. It does not carry the weight of the vehicle as a semi-floater does. On a full floater, a spindle is attached to the outer end of the axle housing.
What does a Dana 80 come in?
ID A Dana 80 Rear Axle in Chevy, Dodge Ram, or Ford Truck IDN-126. Was: Dana 80 Rear Axles have been in production since the 1988 Model Year. They have been used in Chevy/GMC 1992-2002 , Dodge(1994-2002), and Ford (1988-current) trucks vans, and motorhome chassis.
Are full floating axles better?
It is this assembly that carries the vehicle weight. As such, a full-floating axle system is considerably stronger than an equivalently sized semi-floating system. For those of you who carry heavy loads, this means your axle load capacity is greatly increased with a full-floater.