How many watts is a Kenwood KAC 7204?
Kenwood KAC-7204 2-channel car amplifier 170 watts RMS x 2 at Crutchfield.
How many watts is a Kenwood KAC?
Kenwood KAC-7202 2-channel car amplifier 150 watts RMS x 2 at Crutchfield.
How many watts is a Kenwood KAC 7252?
Kenwood KAC-7252 2-channel car amplifier 170 watts RMS x 2 at Crutchfield.
How many watts is a Kenwood KAC 8104d?
Amplifier-Specifications
| Maximum power output (4Ω) | 1000W x 1 |
|---|---|
| Frequency response (+0dB, -3dB) | 5Hz ~ 200Hz |
| Operating voltage | 14.4V (11V ～ 16V allowable) |
| Maximum current consumption | 40A |
| Dimensions (WxHxD) | 280 x 59 x 238(mm), |
What gauge wire should I use for a 1000 watt amp?
1/0 AWG
Why Use Quality Audio Wire
| Amp Kit AWG (Wire Size) | Amplifier Wattage |
|---|---|
| 1/0 AWG | 1000 Watts RMS and up |
| 4 AWG | 500 – 1000 Watts RMS |
| 8 AWG | 250 – 500 Watts RMS |
| 10 AWG | Less Than 250 Watts RMS |
How do you hook up a amp without a RCA jack?
Method #1: RCA Adapter If it can, you can use the cables and connect it to adapters. In this method, the rear speakers will be used to connect to the RCA output. Then, connect the adapter to the rear speaker wires while hook the other end of the cable to the RCA outputs.
Can an amplifier drain your battery?
Most stock audio systems (without subwoofers) will only draw roughly 5-10 amps (60-120 watts). These systems are designed to sound good without demanding too much from the battery. 48 amp hours would run a 5-amp audio system for 9.6 hours before it would be fully drained.
What happens if the power wire is too small for an amp?
Under sized power wires get hot. The voltage drops. The hotter the wire the higher the resistance.
Can I install a amp to my factory stereo?
Usually, you’ll be installing a 4-channel amplifier with speaker-level inputs. The best way to connect it to a factory system is to tap into the stereo’s speaker outputs for the amp’s input signal. Then send the amp’s outputs back to the stereo’s harness, and on to the speakers through the factory wiring.
Do RCA cables go to input or output on amp?
RCA cables and speaker wire. Amp wiring kits often don’t include signal wiring. Your amplifier gets its input signals from the receiver’s output typically via RCA cables.
Will a capacitor help my alternator?
If you have a lacking electrical system and you add a capacitor then you add more load to the alternator. Now the alternator has to charge the battery, supply the amplifiers AND recharge the capacitor.