How do you fix a door rubbing on the floor?

Fix #1: Tighten the Hinge Screws Screws magically work themselves loose over the years. If your door rubs near the top or drags on the floor, use a screwdriver, not a drill, to tighten the screws. With a drill, you’re more likely to over-tighten the screw and strip the screw holes or chew up the screwheads.

Table of Contents

What should the gap be between door and frame?

Hold the new door in the frame to see if it needs adjustment. A well fitted door should have a 2mm gap on either side and at the top. The gap at the bottom will depend on the thickness of your flooring/carpet.

How do you shave the bottom of a door without removing it?

To sand the bottom of a door without removing it, put the sandpaper on the floor, grit side up, and pull the door back and forth across it. Planing is usually the last resort, since it will mean touching up the planed area with a sealer or finish to match the door. A rasp-type plane will often do the best job.

Why is my door scraping the floor?

Doors bind and scrape for several reasons, but it’s frequently due to loose hinges or slight movement in the building, which throws door openings slightly off square. The result is a door that scrapes, is noisy to open and can even end up damaging your floor.

How do you adjust door gap?

Open the exterior door. Examine the weatherstripping on the bottom of the door to see if there are holes or worn areas.

Pull the weatherstripping toward the outer edge of the door.

Measure the weatherstripping,then buy another piece that’s slightly longer.

Pry out the old weatherstripping from inside the door frame using a flat-head screwdriver.

How to adjust hinges on interior doors?

Poorly aligned cupboard doors. If the cupboard doors are poorly aligned,unscrew the two screws that directly connect to the cupboard vertically.

Off-centre cupboard doors. If the cupboard doors are slightly off centre,they can be moved horizontally.

Cupboard door at an angle.

Creaking cupboard doors.

How to adjust a self closing door hinge?

Examine the gap between the unhinged side of your door and the frame.

Unscrew the bottom hinge on your door. You can use a screwdriver or drill to unscrew the door hinge.

Check the edge of the mortise for compression marks.

Use a utility knife to cut along the compression mark lines.

Use a chisel to remove the excess wood from the mortise.

How to adjust misaligned door?

Tighten the Hinge Screws. If the door is misaligned so that the top of the door scrapes against the top of the door jamb,the door’s top hinge screws may

Replace the Hinge Screws.

Drive a Screw or Two Into the Door Jamb.

Tighten the Strike Plate.

Move the Strike Plate Incrementally.

Move the Strike Plate Farther.