How do I setup my Actiontec WiFi extender?
Setting up in-home Wi-Fi on your Actiontec wireless extender
- Log in to the extender.
- Click Wireless Setup.
- Click Wireless Security.
- Enter the password and security settings for each band, 2.4GHz and 5GHz.
- If you want to change the wireless channel width and wireless channel number, click Basic Setup.
How do I access Actiontec WCB3000N?
Logging in to the Actiontec WCB3000N wireless extender
- Open a browser on your home computer.
- Enter the username and password and click OK. NOTE: The default username is admin and the default password is admin. You’ll see the extender’s home screen.
How do I reset my Actiontec WCB3000N?
Reset Button: Holding the reset button down for 10 seconds will restore the unit back to the original factory default settings. The Power port is used to connect the Power Cord to the WCB3000N.
What is Verizon WCB3000N for?
With the WCB3000N, you can provide reliable whole-home wireless coverage to your subscribers. The MoCA or Ethernet-based adapter extends a homeowner’s Wi-Fi network to an area of the home where wireless coverage was previously weak, such as a dead zone in the 2nd floor bedroom or 1st floor family room.
How does the Actiontec wcb3000n WiFi network extender work?
The WCB3000N WiFi Network Extender communicates directly with your Actiontec router over your home’s existing network. The extender takes the credentials from your existing Wi-Fi network and creates a second network with the same name. This means that your devices go from one network to the other, seamlessly.
How do I connect the wcb3000n to the ecb2500c?
If there is already a coaxial cable plugged into the outlet, connect the WCB3000N as displayed in Figure C. If there is NOT, follow the diagram in Figure D. Step2Plug one end of the Yellow Ethernet Cable into an Ethernet Port on your Router/Gateway. Plug the other end into the Ethernet Port on the back of the ECB2500C.
How do I reset the wcb3000n to factory default settings?
• Reset Button: Holding the reset button down for 10 seconds will restore the unit back to the original factory default settings. • !e Power port is used to connect the Power Cord to the WCB3000N. • !e label indicates the factory default GUI access username, password, Network SSID names and security keys.
How do I check the status of my wcb3000n extender?
Log in to your Actiontec or Zyxel gateway/modem by entering 192.168.1.254 into the address bar of your Internet browser. The IP address of your WCB3000N should be displayed on the main or Home page of the Actiontec and on the Status page of the Zyxel. The Extender’s GUI “Status” screen appears, as shown below.