How do I replace the glass screen protector on my Iphone?
What to Know
- Easiest: Aim a hairdryer on a low setting at the screen for 15 seconds to loosen the adhesive. Pull the protector at one corner and peel the sides.
- Alternate: Pry up a corner of the protector with a toothpick. Peel it along the side.
- Peel the film from the replacement’s sticky side.
How do you put a screen protector on an iPhone without air bubbles?
Once you’re sure the screen protector is aligned, gently yet firmly press and run your finger down the middle of the screen to begin adhesion, and remove the install guide. Then, using your finger and the microfiber cleaning cloth, push any remaining air bubbles to the edges of your screen.
How do I make my screen protector stick again?
Method #1:
- Place the sticky side under running water.
- Gently use soap to clean any fingerprints and dust.
- Use a hair dryer to dry both sides of the protector.
- If room dust lands on the sticky side again, turn the packaging tape into a loop and use it to remove any remaining dust.
Can I remove my screen protector and put it back on?
While some people have found ways to do this somehow successfully, it is generally not advised to reuse a tempered glass screen protector. Once removed from the original device, the glue left on the protector attracts dust.
How do I stick my phone to a screen protector?
Make sure that it fits, or exchange for a different screen protector size. Clean the phone using the included microfiber cloth. Peel the backing of the screen protector off. Pull the applicator down to stick the screen protector on.
Will air bubbles go away on a glass screen protector?
If you apply the screen protector incorrectly or the screen isn’t perfectly level, air bubbles may appear beneath the surface. Once you apply a screen protector, you can’t easily remove air bubbles in the middle unless you take off the screen protector and put it back on again.