How do I fix my Nissan P0507?

The standard engine idle is usually between 600-800 RPM depending on the model of the vehicle. How Do I Fix Code P0507?…

Table of Contents

STEP 1: USE FIXD TO ENSURE NO OTHER ENGINE CODES ARE PRESENT.
STEP 2: INSPECT THE INTAKE AND VACUUM LINES.
STEP 3: CLEAN THE IDLE AIR VALVE AND THROTTLE BODY.

How do you reprogram a throttle position sensor?

How to Reset Throttle Position Sensor

Put the key in the ignition.
Turn the key to the On position, without cranking the engine. Wait a few seconds, then turn it off.
Repeat the second step.
Crank the engine.
Pull the parking brake.
Set the gear lever in Drive.
Wait 5-10 minutes.

Do you have to reset computer after replacing throttle position sensor?

After replacing the throttle body to your engine, if the engine light was on and has a pending code, the code will go away. If the code was a hard permanent code, then the ECM (computer) would need a hard reset.

What would cause a P0507 code?

On average, most PCMs will trigger Code P0507 if the idle engine speed is 200 or more RPM higher than designed, and the ‘Check Engine’ light will appear on the dashboard.

What could cause a P0507 code?

Causes of the P0507 Code Vacuum leak. Air intake leak after throttle body. Leaking vacuum from EGR valve. Defective positive crankcase ventilation (PCV) valve.

Does the throttle body need to be reprogrammed?

Code errors can cause your throttle position sensor to work erratically or incorrectly. Otherwise, you’ll need professional software to reprogram your sensor. This job is best done by a professional mechanic. If your sensor just needs repairs, it could be the result of faulty or loose wiring.

How do I reset my idle speed?

You can reset the idle air control (IAC) valve by turning the car on, putting the car into park, pressing the brake down, then pushing the gas pedal down, counting down about 5 seconds, turning the car off, waiting 10 seconds and start the car again, checking to see if the car is idling properly.

How do you reset the throttle body?

Make sure that the accelerator pedal is fully released. Turn ignition switch “ON” and wait at least 2 seconds. Turn ignition switch “OFF” wait at least 10 seconds. Turn ignition switch “ON” and wait at least 2 seconds.