How do I connect Neptune Apex to New WiFi?

If you put it into WiFi Setup Mode by pressing the reset button for 6 seconds until the logo turns blue, you need to follow these steps:

Table of Contents

Connect your phone to the Apex_Setup### WiFi network.
Browse to http://172.16.0.1.
Select your WiFi name from the list.
Enter your password.
The Apex will reboot and connect to your WiFi.

How do I set up my apex Jr?

Plug the Apex Jr’s temperature probe into the temperature connector. Plug the Apex Jr’s Ethernet cable into the Ethernet jack on the Jr base module, and plug the other end of the Ethernet cable into an unused port on your router. Once the Ethernet connection has been established apply power to the Apex Jr base module.

How do you set up Apex probes on Neptune?

pH Calibration Instructions

1) Click the Configure icon to expand to reveal more settings.
2) Click the Inputs Icon.
3) Select pH probe. It will redirected to the pH configuration page.
4) Select Automatic Probe Calibration. Follow the instruction on the screen.
5) Click the Dashboard icon.

How do I access my apex fusion settings?

To access your Apex Fusion account settings and a variety of other useful help menus, click on your user name in the top right corner. Many people ask, “Is there an App?” The answer to this question is “Yes” and “No.” No, there is not an App you need to go download from the Apple Store or Google Play, configure and keep up to date..

How do I set up the apex to factory settings?

The Apex status light will go from Orange> Green> Purple> Green> Orange. To put the Apex into WiFi access mode press and hold the button for 5 seconds. The Apex status light will go from Orange> Green> Purple> Green> Orange> Blue. To initialize the Apex to factory settings press and hold the button for at least 60 seconds.

How do I generate my apex fusion connection token?

To generate your connection token go to your Apex Display module, tap the center button and scroll to “Apex Fusion: Link,” then tap the center button twice Note: If this says “Apex Fusion: Down,” then please Contact Neptune Systems Support.

How do I update the firmware on my apex controller?

To determine your current firmware, go to your Apex Display module and press the center button, then navigate to “Self Test” If your controller is running a Rev less than 4.32, then you will need to update the controller’s operating firmware. Please navigate here to update the firmware.