Does iiNet use VLAN tagging?

NBN™ FTTP, FTTC, HFC or Wireless. NBN™ FTTB/FTTN. NBN™ Satellite. ULTRA FTTB….NBN™ FTTP, FTTC, HFC or Wireless.

Table of Contents

Internet Service Provider (ISP):	Other (Do not select “iiNet”)
VLAN Tagging*:	ON or Enabled
VLAN ID*:	2

Does iiNet use dynamic IP?

NBN™ Fibre to the Building or Node (FTTB/FTTN) NBN™ FTTC or HFC….NBN™ FTTP or FTTH.

Internet Service Provider (ISP):	Other (Do not select “iiNet”)
Mode/Modulation:	WAN
Connection Type/Mode/WAN Type:	IPoE or Dynamic IP address (If this doesn’t work, try PPPoE – this setting is required for select locations)

Is NBN a PPPoE?

Spintel doesn’t use DHCP, it uses PPPoE to deliver the NBN. PPPoE is a kind of internet delivery that requires you to go into the backend of the modem to configure details provided by your ISP. It’s not always the case, but is commonly so.

How do I convert PPPoE to IPoE?

How to reconfigure your Wifi Router from PPPoE to IPoE (DHCP)

Log in to your router’s setup page.
You’ll need to configure your router for DHCP for all SkyMesh services.
Once you have selected DHCP (IPoE) and saved/applied it, you’ll need to turn your router off and back on again.

Can I use my own router with iiNet NBN?

Note: to use your own modem with an iiNet NBN service, your modem must allow you to change the VLAN settings (commonly known as VLAN tagging). Please check your modem manufacturer’s website for more info.

Does iiNet NBN support IPv6?

iiNet. iiNet does NOT offer native IPv6, the trial 6RD offering has also come to an end. If you want IPv6 going forwards the recommendation is to churn to an Internode service which supports native dual stack IPv6.

How do I configure my iiNet router?

Connect the power cable from your modem’s Power port to an electrical outlet. Connect the included Ethernet cable from the UNI-D1 port on your NBN Connection Box to your modem’s blue WAN port. Make sure the electrical outlets for your modem and NBN Connection Box are on, and press the modem’s ON/OFF button.

What is a PPPoE connection?

Point-to-Point Protocol over Ethernet (PPPoE) combines PPP, which typically runs over broadband connections, with the Ethernet link-layer protocol that allows users to connect to a network of hosts over a bridge or access concentrator.

What is the difference between PPPoA and PPPoE?

1. PPPoE means Point-to-Point Protocol over Ethernet while PPPoA means Point-to-Point Protocol over ATM. 2. PPPoE encapsulates PPP frames inside the Ethernet frames while PPPoA encapsulates frames inside AAAL5.

Should I use PPPoE or IPoE?

Unlike the PPPoe, IPoE is easy to use and does not need any client dial-in software. IPoE authenticates and charges users based on their physical location (identified by a unique VLAN ID / PVC ID). Users do not need to enter a user name and password when they access the Internet.

What modem router does iiNet use for NBN?

Compatible modems

Modem	NBN Superfast	NBN Ultrafast^
Smart Modem Gateway (TP-Link VX420-G2H)	✅	✅
TP-Link VX420-G2V Modem	✅	✅
D-Link DIR-2150	✅	❌
D-Link DIR-X1560	✅	❌