What are automated faders?
The Automated Fader is a volume control that can be programmed to change over time. It can be used to attenuate, amplify or mute part of a track. It can also be used to turn off Reverb or Echo effects if used in an Effect Return section or in a Parallel Effect.
What is the point of motorized faders?
Simply a fader attached to some type of motor for the purposes of automation control. Motorized faders are commonly found in mixing boards with automation. These systems work by recording and saving as data the positions and movements of the faders as an engineer mixes.
What does the fader do on a mixer?
Faders are most commonly used on mixing boards and graphic equalizers, where it is nice to have both an easy way to move the level up and down, and to provide a sort of graphic representation of the relative levels of many channels (or frequencies in the case of an EQ).
How long do motorized faders last?
300,000 Cycle Lifespan Designed to provide flawless performance for up to 300,000 cycles, the X32 MOTOR FADER is the exact same 100 mm fader that came in your X32 Digital Mixing Console.
What is the difference between gain and fader?
The input gain(trim) of a mixer is used to get an optimal signal into the board (not too high causing distortion and not too low resulting in a high noise floor). The fader then takes that optimal signal and sends out at whatever level is needed.
What is the difference between gain and volume on a mixer?
Volume is the actual loudness of the output on the channel. It controls the loudness – but not the tone of the audio. Gain is the loudness of the input on the channel. It controls the tone – but does not affect the loudness.
Are faders logarithmic?
The fader law is logarithmic so that a small physical change of position while around the unity gain mark on the fader (about 75 percent of the way to the top, usually) changes the signal level by a fraction of a dB, whereas the same physical movement towards the bottom of the fader might change the signal level by …
What is a long throw fader?
Cigarette manufacturers took to using the term “King-Size” or “100’s,” whereas fader manufacturers use the generic term “Long Throw” to denote various lengths-of-throw that don’t cause your fingers to cramp up during long sessions.