How do I control my Trane air Fi thermostat?

Manual Control

Table of Contents

Step 1: Press and hold the ‘System Mode’ button.
Step 2: To set the input temperature setting, all you have to do is push the up or down buttons.
Step 3: If you wish to override the manual temperature, Press the Hold button on the thermostat.

How do you turn off the schedule on a Honeywell Commercial thermostat?

To clear the program schedule on your Honeywell Thermostat, press the “Hold” button. For all scheduled periods, this will overrule the set temperature. The programmed schedule is cleared when you hold down the Hold button, and you will be prompted to enter a new temperature setting for the thermostat.

Why is my Trane air conditioner not cooling?

Your filters may be clogged or dirty Clean or replace the filters. Consult your local Trane Comfort Specialist™ if you are unsure where the filters are located. Your thermostat controls may be set incorrectly Try turning the thermostat off and then on again. Reset to the desired temperature and see if that helps.

What does the hold button on my Honeywell thermostat do?

This is where the “Hold” button on your thermostat comes into play. By pressing “Hold”, your thermostat will lock in the temperature it’s currently at until you change it again. When you are ready for your normal schedule to resume, simply press the “Run” button and return to your typical programming.

What does permanent hold on thermostat mean?

The temporary hold setting is when you change the temperature setting to a different temperature and it stays at that setting until the next schedule change. The permanent hold setting holds the temperature setting you have chosen for an indefinite time. This overrides your scheduled settings.

What does permanent hold on Honeywell thermostat mean?

How do I reset my Trane air conditioner?

Steps In Resetting Your Trane AC Thermostat

Switch off the thermostat.
Locate the circuit breaker.
Turn off the air conditioner from the circuit breaker.
Remove the Trane thermostat from the wall.
Wait for a few seconds.
Switch the air conditioner and the thermostat back on.