How do I set my La Crosse Technology Atomic Clock?

POWER UP

Table of Contents

Insert 2-AA batteries into your Outdoor Sensor.
Insert 2-AA batteries into your Clock.
Adjust time and date settings on your Clock.
Once the Outdoor Sensor is reading to your clock, place it outside in a shaded location.

How do I reset my LaCrosse Radio Controlled clock?

How to Reset the Time on a LaCrosse Weather Station

Turn the LaCrosse Weather Station over, remove the device’s battery cover and batteries from the unit.
Press and hold the “Set” button on the unit for five seconds.
Complete steps 1 through 3 in the “Resetting The Time Using Radio Controlled Time (RCC)” section above.

How do I reset my atomic clock?

Press and hold the “REC” button (D) for 3 seconds. The clock will search for the atomic signal. The clockʼs hands will move to the 12:00 position and the atomic signal will be received within 3-12 minutes. Once the atomic signal has been received, the clock will set itself to the correct time.

What does the wave button on atomic clock?

The WWVB signal is strongest at night. Hold the WAVE button down for 3+ seconds. The hands will automatically reset to the 12:00 position, and the clock will search for the WWVB time signal. If the clock receives the signal, the clock will set automatically to the correct time.

How do I sync my atomic clock?

Atomic Clock Synchronization

Try powering down the clock (unplug it or remove the batteries), then turn it on again to see if it synchronizes.
If the radio controlled clock is a desk top unit, try rotating it 90 degrees.
Place the radio controlled clock along a wall or near a window that faces towards Fort Collins.

Why is my atomic clock not resetting?

If your clock did not change with Daylight Savings Time (DST), make sure the DST switch on the back of the clock is set to ON. If your clock is off by increments of an hour, the Time Zone (TZ) is set incorrectly. Check the Time Zone switch on the back of the clock. If the problem persists, we have a one year warranty.

Does an atomic clock set itself?

Atomic clocks set themselves and automatically adjust for daylight saving time (DST) to provide the most accurate timekeeping standard possible.