How do I get my hot tub out of watchdog mode?
A: This means your spa has deactivated itself and is in watchdog mode. It has disabled itself to prevent further damage. Sometimes, it is just a little power spike and can be fixed by turning the breaker off for 10 seconds and back on.
How do I reset my Sundance hot tub?
Solution: Try turning off the spa for 1-2 minutes, then reboot. This allows ample time for the board to get a full reboot. If problem persists move to next.
What does the red light mean on a Sundance spa?
immediate attention
The indicator light located on the front cabinet panel of the spa is an early detection system that will notify you when the spa needs immediate attention. A solid white light indicates that all operations are normal. A solid red light indicates that immediate attention is required to clear or fix an error code.
What does watchdog call for service mean for Jacuzzi?
If you see dashes (“- – -” or “- – – – -“) or the message “WATCHDOG” on your control panel, do not attempt to use the hot tub. This error message means that the water is dangerously hot (120°F or hotter).
Why does my hot tub GFCI keep tripping?
If your GFCI constantly trips, one of the following issues might be the culprit: Your hot tub heater may be corroded or otherwise damaged. Problems with the heating elements are among the most common causes of GFCI issues.
Is there a reset button on a Sundance spa?
If you press the (UP) button to “ON” then press the (DOWN) to “OFF” and press the (UP) button to “ON” again, you will reset the timer back to 365 days.
Why is my hot tub GFCI tripping?
Why is the light blinking on my hot tub?
If the hot tub is not heating, the light is blinking because the water temperature has dropped more than 2 degrees from the set temperature.
How do I know if my GFCI is bad?
If the GFCI won’t reset or the button doesn’t pop out when you press the “test” button, there may be no power to the GFCI or you may have a bad GFCI. Pro tip: If the “reset” button trips again every time you press it, there may be a dangerous current leak somewhere on the circuit.