How do I access my DNS 320 from the Internet?
How to Access the Web Interface of the DNS-320 Remotely using D-Link Router
- Put a check mark on the row to enable the rule.
- Enter a name for the policy you would like to create.
- Enter the IP Address of the DNS-320 (On Step 2)
- Enter Port 80 both on Public and Private port.
What is D-Link ShareCenter?
The ShareCenter™ 2-Bay Network Storage, when used with internal SATA drives*, enables homes and offices to share documents, music, photos, and videos across the network and on the Internet, so family members, friends, or employees can easily access them.
How do I access my D-Link DNS 321?
Assign a unique name to the DNS-321. The name can be used to access the device from a web browser instead of using the IP address. For example, http://dlink-xxxxxx. This is useful if there is more than one DNS-321 on the network.
How do I access my D-Link DNS-320L?
Open a web browser and enter the IP address of the D-Link DNS-320L to access the Web UI. If you have a DHCP-enabled router on your network, you may need to check the DHCP table to see what IP address the DNS-320L was assigned.
How do I access DNS 323?
The simplest way to access your DNS-323 is to use theEasy Search Utility provided on the CD-ROM. Thiswill automatically detect any DNS-323 devices on your network,allow you to set up network drives in Windows, perform basicconfiguration and access the web configuration interface.
How do I access my D Link DNS-320L?
How do I reset my DNS-320L?
To factory reset the DNS-320L locate the small hole on the bottom of the machine marked “reset”. After the DNS-320L has been powered on for at least one minute insert an unfolded paper clip or tiny screw driver in the hole. Push gently until you feel a click and then hold for 10 seconds. Then release the button.
How do I reset my D Link DNS-323 password?
To reset the DNS-313/323, access the management (web GUI), go toTOOLS – SYSTEM and press Restore. Allow a minute for the device to reset. If you cannot reach the web UI, locate the reset button on theback of the DNS-313/323.
How do I reset my Dlink Share Center?
While the ShareCenter is powered-up, press and hold the reset button located on the rear or bottom of the unit for more than 8 seconds. Note: This procedure should not restore the installed firmware to the factory default version, only the user configurations will be restored to the factory default settings.
How do I reset my DNS 323?